Op dit moment zijn de volgende sensorwaarden beschikbaar in Home Assistant:
Numerieke sensoren (alleen lezen)
- Inside temperature (room temperature)
- Ambient temperature (outside temperature)
- Domestic hot water temperature (Tw)
- Heating/cooling temperature (Tc)
- Heat exchanger water outlet temperature (Tuo)
- Heat exchanger water inlet temperature (Tui)
- Indoor coil temperature (Tup)
- Heating/cooling circuit 1 temperature (Tv1)
- Heating/cooling circuit 2 temperature (Tv2)
- Outdoor coil temperature (Tp)
- Discharge temperature (Td)
- Suction temperature (Ts)
- High pressure (Pd)
- Low pressure (Ps)
- Compressor working speed
- Fan 1 working speed
- Expansion valve setting
- Supply voltage
- Running current
- Average 1h ambient temperature
- Average 4h ambient temperature
- Average 24h ambient temperature
- SG increase setpoint domestic hot water
- SG decrease setpoint cooling
- SG increase setpoint heating
- Actual setpoint heating zone 1 (only a valid value when heating is active)
- Actual setpoint heating zone 2 (only a valid value when heating is active)
- Actual setpoint cooling zone 1 (only a valid value when cooling is active)
- Actual setpoint cooling zone 2 (only a valid value when cooling is active)
Binaire sensoren (aan / uit, alleen lezen)
- Heating switch
- Heating switch circuit 2
- Cooling switch
- Defrost
- Domestic hot water in progress
- Heating in progress
- Cooling in progress
- Water flow switch
- SG ready
- Fault codes
Schakelaar (aan / uit)
- System on/off
- Domestic hot water mode (M9.01)
- Heating mode (M9.02)
- Cooling mode (M9.03)
- Use heating curve (M1.05)
- Domestic hot water ECO mode (M3.09)
- Use domestic hot water timer (M4.01)
- Reduced mode timer (M5.04)
- Use anti legionella mode (M6.01)
Numerieke waarden
- Delta T to stop heat pump (M1.01)
- Delta T to restart heat pump (M1.02)
- Delta T to lower compressor speed (M1.03)
- Domestic hot water setpoint (M3.01)
- Domestic hot water reheating point (M3.02)
- Heating curve ambient temperature (1 through 5; M1.06-M1.10; works for Amber version 2.29 and higher)
- Heating curve water temperature (1 through 5; M1.11-M1.15; works for Amber version 2.29 and higher)
- Cooling setpoint (M1.04; for when cooling curve is not used)
- Heating setpoint (M1.19; for when heating curve is not used)
- Minimum ambient temperature to start domestic hot water ECO mode (M3.10)
- Circuit 1 minimum temperature (M1.20)
- Circuit 1 maximum temperature (M1.21)
Selectiebox
- Working mode (Heating, Cooling, Domestic hot water, Auto)
Berekende waarden
- Delta T (Verschil tussen Tui en Tuo)